What Is the Sortino Ratio, and How Is It Different From the Sharpe Ratio?
The Sortino ratio divides a track record's excess return by its downside deviation — the spread of only the returns that fell short of a chosen minimum — instead of dividing by the full spread of every return the way the Sharpe ratio does. That one change means a strategy with frequent sharp gains and otherwise steady returns stops being penalized as "volatile," since Sortino only counts the bounce nobody actually worries about.
The rest of this page covers how the ratio is actually calculated, the specific blind spot in the Sharpe ratio it was built to close, how to pick the minimum return the formula compares against, and what the number still doesn't tell you on its own.
How is the Sortino ratio calculated?
Take the average return over some period, subtract a minimum acceptable return, and divide by the downside deviation of those same-period returns — a spread measurement built from only the returns that landed below the minimum.
- Pick a minimum acceptable return (MAR) for the period — common choices are zero, a risk-free rate, or a required return the strategy is meant to clear.
- Collect a return for each period (daily, monthly — whatever the underlying data uses).
- For downside deviation, look only at the periods that fell below the MAR. Square each shortfall, average those squares, then take the square root — the same root-mean-square shape as ordinary standard deviation, just computed over a smaller, one-sided set of numbers.
- Subtract the MAR from the average return to get the excess return.
- Divide the excess return by the downside deviation.
- Annualize if needed, the same way the Sharpe ratio does.
The entire difference from the Sharpe ratio lives in step 3. Standard deviation (what the Sharpe ratio divides by) uses every period's distance from the average, above and below. Downside deviation throws out every period that beat the MAR and measures the spread of only the ones that didn't.
What specific blind spot does this fix?
The Sharpe ratio's standard-deviation denominator treats a surprise gain and a surprise loss as the same kind of "risk" — it has no concept of direction, only distance from the average. A strategy that mostly earns a small, steady return but occasionally posts an unusually large gain gets penalized by Sharpe's math exactly as if that large move had been a loss, because both are equally far from the average.
Downside deviation doesn't make that mistake. A period that beats the minimum acceptable return, by any amount, contributes nothing to the denominator — it simply isn't part of the one-sided set being measured. Only a period that falls short counts.
| What happened | Sharpe ratio's read | Sortino ratio's read |
|---|---|---|
| An unusually large gain in one period | Counted as risk — "volatile," same as a loss would be | Not counted at all — it beat the minimum, so it's excluded |
| An unusually large loss in one period | Counted as risk | Counted as risk — this is exactly what downside deviation measures |
| A steady run of small gains near the average | Low standard deviation → high Sharpe | Low downside deviation → high Sortino |
| Frequent small losses just under the minimum | Counted the same as one big loss of equal total distance | Counted — downside deviation squares each shortfall individually |
See what the Sharpe ratio actually measures for the full account of that blind spot and the tail-risk strategy shape it lets through unnoticed — the Sortino ratio is the direct answer to that specific gap, not a different idea.
How much does the minimum acceptable return (MAR) choice matter?
A lot — the Sortino ratio isn't one number, it's a different number for every MAR you pick, and comparing two Sortino ratios computed against different minimums tells you nothing. Three common choices, and what each one asks:
- Zero. Downside deviation measures only the periods that lost money outright, full stop. The simplest and most common default.
- A risk-free rate. Matches the same convention the Sharpe ratio uses for its excess-return numerator, so the two ratios stay comparable side by side.
- A required return. If the strategy exists to clear some specific hurdle — matching a benchmark, meeting a stated target — the MAR can be set to that hurdle, and downside deviation then measures "falling short of the goal" rather than "losing money."
None of these is more correct in the abstract. The honest practice is to state which MAR was used every time the number is quoted, the same way a win rate means nothing without its sample size — see how many calls before a track record means anything for the parallel case of a number that's meaningless without the context attached to it.
Is a higher Sortino ratio always better than a higher Sharpe ratio?
Neither ratio is "better" in general — they answer different questions, and which one matters more depends on what you're actually worried about. A Sortino ratio is the more honest read when the thing you care about is specifically downside risk, which is the normal case for most traders. A Sharpe ratio is still useful when upside and downside bounce genuinely matter equally to how the strategy is meant to behave.
The practical pattern worth watching for: a strategy whose Sortino ratio is noticeably higher than its Sharpe ratio is a strategy with meaningfully more upside bounce than downside bounce in its history — which is a real, checkable fact about the record, not just a quirk of which formula got used. A strategy where the two ratios land close together has roughly symmetric bounce in both directions, and the Sharpe ratio's blind spot barely mattered for that particular record.
What does the Sortino ratio still not tell you?
- It still inherits every limitation the underlying record has. A short record hasn't lived through enough conditions to show its real downside deviation yet — see how many calls before a track record means anything for the same caution applied to a win rate instead of a ratio.
- A backtested Sortino ratio inherits the backtest's own limits. A rule set searched until it happened to avoid the market's worst stretches will report a smaller downside deviation, and a better-looking Sortino ratio, than the strategy's real forward risk — see what curve-fitting is and how it fakes a backtested track record.
- It doesn't size the tail, only notices it more precisely than Sharpe does. A single catastrophic period still only contributes one data point to the downside-deviation calculation — see what maximum drawdown is and why it matters more than win rate for a measurement built specifically to answer "how bad did the worst stretch get," which neither ratio directly answers.
- It says nothing about whether the record is genuine. A cherry-picked window can produce a flattering Sortino ratio the same way it inflates any other summary statistic — see how to spot a cherry-picked track record.
- There's no universal "good" cutoff, any more than there is for Sharpe — a number quoted without its MAR, its time period, and whether it came from a live account or a backtest doesn't mean much on its own.
Questions traders ask
Is the Sortino ratio the same as the Sharpe ratio?
No, though they're built the same way. Both divide an excess return by a measure of spread; the Sharpe ratio's spread counts every period's distance from the average, while the Sortino ratio's spread counts only the periods that fell below a chosen minimum acceptable return. A strategy with occasional large gains and otherwise steady returns scores better on Sortino than on Sharpe, since those gains stop being counted as risk.
Can the Sortino ratio be negative?
Yes — if the average return falls below the minimum acceptable return, the excess-return numerator goes negative, and the ratio goes negative with it. A negative Sortino ratio means the strategy, on average, didn't even clear the minimum it was being measured against.
Does a high Sortino ratio mean a strategy has no real downside risk?
No. It means that, measured against the chosen minimum, the downside bounce the record actually experienced was small relative to its excess return. A record that simply hasn't lived through a bad stretch yet — one still short on sample size — can post a high Sortino ratio for the same reason a short win-rate sample can look better than it will over time: not enough has happened yet to show the real number.
Why would someone compute both Sharpe and Sortino for the same record?
Because the gap between them is itself informative. Computing both and comparing shows how much of the record's Sharpe-counted "bounce" was actually upside rather than downside — a wide gap says the strategy's real risk profile is better than its Sharpe ratio alone suggests; a narrow gap says the Sharpe ratio was already telling the more complete story.
The Sortino ratio is the Sharpe ratio with one change — its spread counts only downside bounce — and that change closes the specific blind spot where an upside-heavy record gets penalized as if its gains were risk. What it doesn't do is replace the other questions a track record still has to answer: how many periods it covers, whether it's a backtest or a live account, and whether the window it's drawn from was picked honestly in the first place. The methodology behind how any of this gets read in practice, rather than just defined, is on the methodology page.
Keep reading
Get them free